Rod of the pantone reactor
Rod of the pantone reactor
hi everyone voila i just finished mounting on my mower i rotated it for a while about an hour then i tried to remove the steel rod from the reactor to see the result. i was quite surprised that the mower works as well ac or without rod. I then ask myself the question is what the rod does not just reduce pollution and does not affect the operation of the engine. What do you think?
0 x
I'm tired of paying too expensive gas and I've always dreamed of driving with water so that's where I'm going
Hello
A gasoline engine will run without rod
the same as when you leave it cold, push a little the consumption tries you will see the difference
The same panton reactor assemblies, with a small model carburetor instead of the bubbler you can make it work with diesel or fuel oil, there if you remove the rod it will not work, or at least a little at first very hot but the engine smokes and clicks.
When you can run it in oil for an hour, that it doesn't smell anything in exhaust less than a modern diesel, that the candle stays white your settings are good.
Andre
A gasoline engine will run without rod
the same as when you leave it cold, push a little the consumption tries you will see the difference
The same panton reactor assemblies, with a small model carburetor instead of the bubbler you can make it work with diesel or fuel oil, there if you remove the rod it will not work, or at least a little at first very hot but the engine smokes and clicks.
When you can run it in oil for an hour, that it doesn't smell anything in exhaust less than a modern diesel, that the candle stays white your settings are good.
Andre
0 x
yes indeed I am running my engine with gasoline, I will make my assembly more reliable and I will try to add a reduced model carburetor it can be interesting to see the behavior of the engine with a fuel which is not intended for it. of this response
0 x
I'm tired of paying too expensive gas and I've always dreamed of driving with water so that's where I'm going
-
- Similar topics
- Replies
- views
- Last message
-
- 1 Replies
- 9566 views
-
Last message by Christophe
View the latest post
26/06/08, 19:38A subject posted in the forum : Water injection in heat engines: information and explanations
-
- 6 Replies
- 5059 views
-
Last message by MethodTack
View the latest post
18/03/08, 18:09A subject posted in the forum : Water injection in heat engines: information and explanations
-
- 73 Replies
- 102210 views
-
Last message by Christophe
View the latest post
14/03/16, 00:49A subject posted in the forum : Water injection in heat engines: information and explanations
-
- 8 Replies
- 9159 views
-
Last message by Woodcutter
View the latest post
19/01/07, 02:10A subject posted in the forum : Water injection in heat engines: information and explanations
-
- 2 Replies
- 4584 views
-
Last message by PITMIX
View the latest post
31/03/06, 13:12A subject posted in the forum : Water injection in heat engines: information and explanations
Go back to "Water injection in heat engines: information and explanations"
Who is online ?
Users browsing this forum : No registered users and 95 guests