Hello everybody
I'm busy pantomizing a 1000cc petrol corsa.
For the reactor, I removed the exhaust manifold and the calal pot. which was vertical under the collector.
I remade a piece which includes both.
The reactor is therefore vertical just at the outlet of the engine.
To heat, it's impossible to do better.
for arc welding I recommend 1.6 mm stainless steel rods even on normal steel.
it's easier for novices of the bow.
remember to tilt the electrode 30 degrees from the vertical and pull your cord.
the distance from the electrode is good when the noise is harmonious.
the speed of advance of the electrode depends on the perforation or not.
from 30 to 50 Amperes per mm of electrode.
the ideal is of course the MIG or semi-automatic station
Good work
Pantonisation TU 1.4 75 Ch
- do you drive
- I understand econologic
- posts: 102
- Registration: 20/08/05, 16:53
- Location: Belgium
- x 3
-
- Similar topics
- Replies
- views
- Last message
-
- 1 Replies
- 3211 views
-
Last message by loop
View the latest post
02/06/08, 13:14A subject posted in the forum : Water injection in engines: montages and experiments
-
- 27 Replies
- 22774 views
-
Last message by Other
View the latest post
10/03/08, 21:09A subject posted in the forum : Water injection in engines: montages and experiments
-
- 0 Replies
- 6017 views
-
Last message by henri
View the latest post
23/06/05, 22:46A subject posted in the forum : Water injection in engines: montages and experiments
Back to "Water injection in the engines: the assembly and experimentation"
Who is online ?
Users browsing this forum : No registered users and 132 guests