Pumping over sun

Work concerning plumbing or sanitary water (hot, cold, clean or used). Management, access and use of water at home: drilling, pumping, wells, distribution network, treatment, sanitation, rainwater recovery. Recovery, filtration, depollution, storage processes. Repair of water pumps. Manage, use and save water, desalination and desalination, pollution and water ...
gerald222
I discovered econologic
I discovered econologic
posts: 7
Registration: 26/05/11, 19:23

Pumping over sun




by gerald222 » 26/05/11, 21:36

good morning or good evening.
my project I have a river 40 m from our shed water height minus 1 m from the ground + 20 m flat
I would like to pump water to the tan shed that there is sun 9 am to 18 pm we are in the south I have retained a pump and a solar panel
www.conrad.fr/pompe_submersible_12_v_p_ ... 618_217151
https://www.econologie.com/shop/panneau- ... p-109.html
is this panel sufficient to run the pump non-stop during the day.
thank you in advance for your advice.
0 x
dirk pitt
Econologue expert
Econologue expert
posts: 2081
Registration: 10/01/08, 14:16
Location: isere
x 68




by dirk pitt » 26/05/11, 21:54

your conditions would seem more suitable for a ram pump.
0 x
Image
Click my signature
User avatar
Gaston
Econologue expert
Econologue expert
posts: 1910
Registration: 04/10/10, 11:37
x 88

Re: Pumping over the sun




by Gaston » 27/05/11, 09:34

In my opinion, no ...
The power of the pump is approximately equal to the power maximale of the panel, but this maximum power is reached only a few tens of minutes during the day.
One might hope that the pump runs with a reduced flow, but it is rather to fear that it does not even start.

For safer operation (even with a few clouds), a 20W panel seems to me a minimum.

PS
Be careful with this pump: depending on the model chosen, some do not support more than 30 minutes of continuous operation ...
0 x
gerald222
I discovered econologic
I discovered econologic
posts: 7
Registration: 26/05/11, 19:23




by gerald222 » 27/05/11, 09:51

Hello again
thank you for your quick answers for the ram pump I read your posts a lot but complicate my home too weak water current.
I will therefore provide a 20w panel for the pump, it specifies the site ... Our model BWV 04 (article code 53 90 90) allows permanent operation on 6 to 9 V thanks to the water cooling of the engine.
do you have addresses of other pump because at 14euro90 it seems fragile to me.
0 x
User avatar
Gaston
Econologue expert
Econologue expert
posts: 1910
Registration: 04/10/10, 11:37
x 88




by Gaston » 27/05/11, 10:28

gerald222 wrote:Hello again
thank you for your quick answers for the ram pump I read your posts a lot but complicate my home too weak water current.
I will therefore provide a 20w panel for the pump, it specifies the site ... Our model BWV 04 (article code 53 90 90) allows permanent operation on 6 to 9 V thanks to the water cooling of the engine.
Please note: this pump is therefore designed for 6 to 9 V whereas the well exposed panel can easily exceed 15 V :!:
gerald222 wrote:do you have addresses of other pump because at 14euro90 it seems fragile to me.
I think that is indeed the risk.
Perhaps here ?
0 x
User avatar
tigrou_838
I posted 500 messages!
I posted 500 messages!
posts: 573
Registration: 20/10/04, 11:25
Location: Lorraine border luxembourg

pumping over the sun




by tigrou_838 » 27/05/11, 11:04

hi gerald222

you can always pump with your little pump, in a reserve very close to the river and then by gravity do the 40m flat to your shed.

I think the ram will be good in this case, with less than 1m20 you can do largely what you want, even with a very low flow, but 24/24 and 7/7

or another idea, a small paddle wheel which drives a mechanical pump to send the water 24/24 to your reserve.

tigrou
0 x
gerald222
I discovered econologic
I discovered econologic
posts: 7
Registration: 26/05/11, 19:23




by gerald222 » 27/05/11, 12:19

Attention: this pump is therefore designed for 6 to 9 V while the well exposed panel can easily exceed 15V .....

it means that the pump will receive too much voltage ???? are there 6a9v panels or a regulator ????
0 x
Alain G
Econologue expert
Econologue expert
posts: 3044
Registration: 03/10/08, 04:24
x 3




by Alain G » 27/05/11, 13:16

gerald222 wrote:Attention: this pump is therefore designed for 6 to 9 V while the well exposed panel can easily exceed 15V .....

it means that the pump will receive too much voltage ???? are there 6a9v panels or a regulator ????



The small panel of 10 watts will never go up to 14 volts with this pump and I doubt as gaston which starts well otherwise it will not rotate fast enough to raise the water enough, I would include a battery and intermittent operation using a little timer that you can find at Conrad!
0 x
Stepping behind sometimes can strengthen friendship.
Criticism is good if added to some compliments.
Alain
gerald222
I discovered econologic
I discovered econologic
posts: 7
Registration: 26/05/11, 19:23




by gerald222 » 27/05/11, 14:02

taking into account that I have at least 1m in the river where I will place the pump 20 my flat distance from the shed river and 40m in height from the fountain outlet when it arrives gives me 1m in delivery height and the pump gives 2m playable or not
0 x
User avatar
Gaston
Econologue expert
Econologue expert
posts: 1910
Registration: 04/10/10, 11:37
x 88




by Gaston » 27/05/11, 14:05

gerald222 wrote:So I will provide a 20w panel for the pump
Alain G wrote:The small 10 watt panel will never go up to 14 volts with this pump
The 10W, no, but the 20W probably.

Alain G wrote:I would include a battery and intermittent operation using a small timer
Personally, I would not put a battery in such a system.
The water tank is there to ensure storage, no need to also store energy.
In addition, a battery will necessarily age.

The "over the sun" pumping system is a good idea.
You just need to size the pump and the panel correctly (there are "kits" in which the elements are sized to work together as this one for example)
0 x

 


  • Similar topics
    Replies
    views
    Last message

Go back to “Water management, plumbing and sanitation. Pumping, drilling, filtration, wells, recovery ... "

Who is online ?

Users browsing this forum : No registered users and 256 guests