scooter 2t (100 engine cm²)

Water injection in thermal engines and the famous "pantone engine". General informations. Press clippings and videos. Understanding and scientific explanations on the injection of water into engines: ideas for assemblies, studies, physico-chemical analyzes.
corgansd
I discovered econologic
I discovered econologic
posts: 3
Registration: 01/08/05, 20:22

scooter 2t (100 engine cm²)




by corgansd » 17/02/06, 11:05

Hello everyone
I have a scooter 2t 100cm² that I would pantoniser. having gone through the post dealing with this subject. the simplest system would be water doping (system g if I followed everything well).
but a problem (among many other surely) arises: the muffler is not as long as on the car, so that the pot through the bulor must change the elbow from the engine to the pot?
Is someone already doing this?
0 x
Christophe
Moderator
Moderator
posts: 79121
Registration: 10/02/03, 14:06
Location: Greenhouse planet
x 10973




by Christophe » 17/02/06, 12:16

Difficult to pantoniser 100% 2Tps for lubrication problem.

And for the water doping I'm afraid that modifying the exhaust will drop the perf engine (unless working the acoustic agreement).

Anyway you can always have a look here: https://www.econologie.com/forums/mini-chopper-t954.html

This is the experience that most resembles your project.
0 x

 


  • Similar topics
    Replies
    views
    Last message

Go back to "Water injection in heat engines: information and explanations"

Who is online ?

Users browsing this forum : No registered users and 92 guests