The titin has charged all night and this morning it starts. Yesterday I immediately unplugged the assembly. But then I dry off ... How could the go heater have pumped my battery? Be careful, if you are missing one screw in 2, you could have everything that is blocked and a hot gas leak, .... you can ...

I have just slipped the plate with difficulty, one of the 2 screws is not fully tightened, it is blocking. Problem, I run the starter, and there it makes 3 turns and then goes away ... There is a beep that sounds. The odb displays the LEDs and at the start the counters then turns off. I put it to load in me ...

It'll be weird if your fuel heater is running at full speed. Yes the rta says (if c really the heater pacque the rta says that it is on the common rail, but there is nothing ms c well a green connector) that after contact is permanent but c the ground which disconnects qd the temp is bo ...

So I finally connected the probe to the green connector of the GO filter holder (fuel heater or water presence detector, not on). It was a bit dirty DIY but I was fed up. At least that after contact and it was not a hassle. The temperature of the water jar after 15 mi ...

Good, for the moment you are right Flytox, I will be enough to ensure / improve the existing one. I continue to consume at the cleat of the fleet and for good reason, I barely pull the accelerator cable that bubbles. And in + for the moment it remains cold at the beginning (probe not connected ms ca heats up quite quickly kd m ...

It's been a lot yes pr 10 k. Is the restriction a clamp on the pipe ?! With the egr, I counted on a suction of the escapement until the bubbler. I'm not sure I understood you. Ms c on that I do not know what it can give and I risk to hesitate for a long time. Yet I want to make a devia ...

Here is the diagram of my doping: https://www.econologie.com/fichiers/partager3/1395909410ZyZzIb.jpg The photo of the engine with the bubbler: https://www.econologie.com/fichiers/partager3/1395908481LHSZ0x.JPG " sometimes there is a joke ": what do you mean? In any case, that's going to ask ...

Here it is, the bulleux is installed and I started the engine with anxiety. He purrs ... It doesn't bubble though. I stayed at idle and haven't plugged in the heating probe yet. I'm not sure but is the aspiration well done by starting the turbo? I do not see...

A is almost finished installation. Only + fix the bulb and connect it to 1 + after contact. Tomorrow. It took me hours. I think that econokit has never installed on a picasso .. https://www.econologie.info/smileys/Spamafote.gif From below, I was able to install the reactor on the ...

I bought fire gum. Too bad I couldn't remove the reactor anymore. For life with the picasso ... I'll try it tomorrow. As for the cap, I must have 20 hp less due to I do not know what. the flowmeter is clean. the egr valve cannot be dismantled dc inverifiable. c not the turbo otherwise there will be ...