Fresh news from Padawan

Innovations, ideas or patents for sustainable development. Decrease in energy consumption, reduction of pollution, improvement of yields or processes ... Myths or reality about inventions of the past or the future: the inventions of Tesla, Newman, Perendev, Galey, Bearden, cold fusion ...
Padawan
Éconologue good!
Éconologue good!
posts: 260
Registration: 05/01/06, 13:27
x 6

bravo!




by Padawan » 07/02/09, 11:57

Well done Gregyx
You understood 1/4 of the song as you say!
It is indeed this principle adopted, but the blow of this small accelerator with hard drive is only the beginning then to realize my flash ramp ... because there! there is a combination of several kinds of magnet to be sure that the ball at any point of the circuit will undergo an increasing gradient of the magnetic field ^ and attention I used cubic magnets of 5 * 5mm for the basic accelerators therefore easier to combine the faces (remember the famous HALBACK montage) there are several
way to finish a "RubiCube" !!! .... I told you that we could make the field grow and decrease in the ramp.
actually it is not extraordinary the hard drive model!
although with my combination it is retained as one of the ideas
to patent.
For your old dream of all taken to cross the "wall of the perpetual" there you have to think about the intrinsic property of materials, because a magnetic field MUST ALWAYS CLOSE .... it is a law of the physics of these materials but !!!
think of the materials that we are constantly combining today (Galodonium (magnetic fridge), new rare earth materials ....!)
Me for now I try several things and note my progress little by little and then even if the ball made the complete turn, it will surely arrive at the end of several days or months or the ball will demagnetize or will gradually change the spins of the " miracle materials "which will allow the famous passage of the" holy grail! "
Go for now let's stay in the realm of achievable
but by always innovating a little more !!
by the way I don't know all if you noticed in the beginning of the video I show my flash ramp (live just after the title)
no one noticed a detail on what I tell you about the famous materials look well or the ball stops !!!! ????
it does not go beyond the famous trap and stops net ???? !!!! hihi !!

A+
0 x
Back to the future
User avatar
gegyx
Econologue expert
Econologue expert
posts: 6930
Registration: 21/01/05, 11:59
x 2870

Re: well done!




by gegyx » 07/02/09, 13:16

Padavoine wrote:Well done Gregyx
You understood 1/4 of the song as you say!

: Lol:

Thank you, as I had equipment, I made this beginning of the model, at random, of course.
I saw that you were using cubes, and that with the cylinders the flow was less regular between the magnets.
As there is no indication of position in your video (patent requires), we can only guess.
When you talked about " my goal is to demonstrate that we can make combinations
magnets to get what you get in a DC machine to vary the intensity of the field, there is also the possibility of creating fairly special magnets, I did the simulations because my ramp is a complex combination
», I deduced from this that you had done in the HALBACK genre.

After seeing the course of my ball, I understood that once the ball at the top, it might not be worth accelerating the ball following the same progression, there could be trays or a drop to be able to resume the process without having at the end, the last magnet very, very, too close ...

Then I thought of a springboard system at the end that would keep the ball away from the end.
There may be a trigger that controls an annihilation of the last field or more flow in the right direction.
Or as there is interest right now, at a flow switch.

I saw the stop of your ball on an obstacle, which made the visible magnet move.
Well, we always wonder if it is a little about construction or a hidden complementary system (a taste of what comes next…).

Your advantage is to know how to calculate energies, and to see if a system is not viable.

Image
0 x
Padawan
Éconologue good!
Éconologue good!
posts: 260
Registration: 05/01/06, 13:27
x 6

That the "quiet" force




by Padawan » 07/02/09, 13:27

Well done Gregyx!
I'm sure you could find the system but don't forget
not the materials !?
What is your feeling on the passage of the ball beyond the magnetic trap?
The next helical ramp is harder than we think ...
I'm looking for magnetic simulation software because the lab
can't materialize my "too complex" systems? does he say ??
Well done research !! PFFF !!!!
finally if you know 3D Freeware!
A+
0 x
Back to the future
xboxman4
I understand econologic
I understand econologic
posts: 120
Registration: 09/07/08, 20:04
x 2




by xboxman4 » 07/02/09, 14:49

Hi, congratulations Padawan for your achievements. By cons you use the spiral magnet system well? like for example those:

http://www.youtube.com/watch?v=hS2LEXuI ... re=related

http://www.youtube.com/watch?v=iS1AqTIyJHI

And then why wouldn't you try to use the impulse of a coil to allow the ball to make a new cycle on your ramp?
0 x
User avatar
elephant
Econologue expert
Econologue expert
posts: 6646
Registration: 28/07/06, 21:25
Location: Charleroi, center of the world ....
x 7




by elephant » 07/02/09, 15:28

I still think that if we remove the magnets on the left side, gravity will resume its rights to give a new impetus to the ball. It will not be a perpetual movement there will in fact be an energy supply which is that of gravity.
0 x
elephant Supreme Honorary éconologue PCQ ..... I'm too cautious, not rich enough and too lazy to really save the CO2! http://www.caroloo.be
Padawan
Éconologue good!
Éconologue good!
posts: 260
Registration: 05/01/06, 13:27
x 6

single magnets




by Padawan » 07/02/09, 15:38

Hello!
yes i have already tested a coil! it works but
it's just good for the patent.
My work horse is to play only with materials!
For the spiral I told you that it was only a starting point ...
A+
0 x
Back to the future
User avatar
gegyx
Econologue expert
Econologue expert
posts: 6930
Registration: 21/01/05, 11:59
x 2870




by gegyx » 07/02/09, 16:03

Padawan / It's nice of you, you are encouraging.
But I keep in mind that "It is not possible, in a closed system".
Not knowing how to calculate the synergy, I go astray in haphazard and incomplete reasoning, even false. And the only way to prove it, is by making models. Unfortunately, the economic situation will not leave me the leisure to benefit from a retirement at 60…

Just a question: is it expressly to write Gregix? (= gregarious?)
: Cheesy:
You know I do this at leisure, without a machine tool, without calculation software, a baccalaureate level and 25 years more than you. So…

Well, apart from FEMM, we were looking for something more elaborate, which already allows a movement simulation… So if you say that your work software is not enough!

As for special or new materials, you will understand that it is not within our reach.
(We are talking about super paramagnetism, special compositions of nanoparticles…)
Apart from indiscretion, chance or intuition ...

I like your approach to the helical ramp, it's a bit like the Quanthomme model with the elevator, upside down (toy gone). The dream remains the engine of research.

Well already with an ordinary progressive helical ramp, I have a hard time conceptualizing the manufacturing, with my means at hand…

"What is your feeling on the passage of the ball beyond the magnetic trap? "
I don't quite understand the question, you mean during? Because after the magnetic trap there should be no more problems, it enters the cycle again.
On your Flash ramp, we can see that the planned track is not the supposed path of a loop.
0 x
Padawan
Éconologue good!
Éconologue good!
posts: 260
Registration: 05/01/06, 13:27
x 6

gegyx




by Padawan » 07/02/09, 17:55

a thousand apologies GEGYX
I had read it wrong!
yes actually with my flash ramp I don't think curly
it was only a researcher who told me about a material
and I tried it on my ramp (movie at the start of my video)
then I removed it because I found the idea great but that I will use in another proto. in fact the ball has passed the trap well, moreover, we can see one of the rectangular magnets which has moved in its passage but the ball was not stopped the material has looped the field well but by reducing it by half at the end of the stroke (I voluntarily stopped him) !!! awesome isn't it !? this is where ALMOST everything becomes possible but it is still necessary to work with a combination of "materials + magnets" because the ball does not cross 90% of the course !! although it is honorable!
we must think that science still owes us answers!
we never know !
you must know:
Researchers who search, we find some!
But researchers who find, we are looking for!

A + good luck
0 x
Back to the future
xboxman4
I understand econologic
I understand econologic
posts: 120
Registration: 09/07/08, 20:04
x 2

Re: gegyx




by xboxman4 » 07/02/09, 18:03

This would mean that it would be possible to close the circuit so that the ball is in continuous movement?
0 x
User avatar
Remundo
Moderator
Moderator
posts: 15992
Registration: 15/10/07, 16:05
Location: Clermont Ferrand
x 5188




by Remundo » 07/02/09, 18:16

yes, except for friction : Cheesy:
0 x
Image

 


  • Similar topics
    Replies
    views
    Last message

Go back to "Innovations, inventions, patents and ideas for sustainable development"

Who is online ?

Users browsing this forum : Google [Bot] and 109 guests