Hello
I installed my pantone system on my bx I have not yet measured consumption.
I have problems keeping my boiler level constant
I use an oil stove fuel float but I have problems with the floats which does not hold (fills with water) I try a polystyrene flush float but after 2 days more float (disintegrate)
I am looking for an electric level detector which can resist temperature (+ 85 °) and vibrations
Who can give me a solution (econology do you have a solution?)
please
constant level for boiler
-
- I posted 500 messages!
- posts: 749
- Registration: 31/03/04, 07:37
- Location: Brussels
Hello,
I plan to show a reactor on my xantia td.
To control the level and consumption I think of using the system that Citron has been mounting for millennia on its LHM vessels. This allows a visual level check and it closes a contact when the level is too low. Coupled with a fuel tank it gives an autonomous system, the heating can be done afterwards in the bubbler, suddenly no problem of floats melting.
I plan to show a reactor on my xantia td.
To control the level and consumption I think of using the system that Citron has been mounting for millennia on its LHM vessels. This allows a visual level check and it closes a contact when the level is too low. Coupled with a fuel tank it gives an autonomous system, the heating can be done afterwards in the bubbler, suddenly no problem of floats melting.
0 x
A CX is Bo ... But it's rusty !!!
- rezut
- I understand econologic
- posts: 191
- Registration: 01/12/04, 14:58
- Location: Chalon sur Saone
- x 2
Hello
very good idea the lhm vase on the other hand no maximum level so it would be necessary to couple a tempo relay to the low level contact which will let flow a little water via a windshield washer pump (for example) for a time determine and turn and play
and why couple a carburetor (there is no longer any need)
for the pantone you will put it or (I put mine in the exhaust pipe which I redid entirely but after the first full I did not notice a drop in consumption)
may be due to lack of cross flow
I try to attach a photo of my montage
very good idea the lhm vase on the other hand no maximum level so it would be necessary to couple a tempo relay to the low level contact which will let flow a little water via a windshield washer pump (for example) for a time determine and turn and play
and why couple a carburetor (there is no longer any need)
for the pantone you will put it or (I put mine in the exhaust pipe which I redid entirely but after the first full I did not notice a drop in consumption)
may be due to lack of cross flow
I try to attach a photo of my montage
0 x
constant level tank
Need help !!!
I want to buy "constant level tank" same in the pictures, anyone can help me? It made from brass.
Many thanks!
Schwinn
THAILAND
I want to buy "constant level tank" same in the pictures, anyone can help me? It made from brass.
Many thanks!
Schwinn
THAILAND
0 x
I'm from THAILAND
Back to "Water injection in the engines: the assembly and experimentation"
Who is online ?
Users browsing this forum : No registered users and 147 guests