Flytox wrote:What's the mouth of the rod with the km?
No idea, we didn't take it apart to see ..
We have a second reactor almost ready for replacement, but it won't be before a week.
Flytox wrote:It seems to me that André spoke about this several times, that it worked better with little water at the bottom of the bubbler. Higher water temperature in the bubbler? and / or greater volume above the water giving "better" steam? If you could measure the temperature of the fleet in both cases, we could move forward a bit !?
The temperature is not very high .. because there is no heating system for the water, but the bubbler is "heated" by the air from the radiator, because it is quite close.
but I don't think the water is over 40 ° C.
Flytox wrote:In one of my "projects" not yet realized, there is a system with a very small 12 v pump (which supports hot water) which very slowly fills the bubbler from below. In the bubbler, there is an overflow which allows: a constant level of float and water to return to a 5 liter tank below. The pump sucks into this reservoir and spits into a copper pipe heated by the Coolant. In the end, it spits water at around 85 ° C into the bubbler. You need a small filter on this circuit, otherwise it will not work for long (concretions / algae / bacteria etc ... )
I thought I would do something like that, but not obvious and it must be reliable over time.