Hello, after a short time of absence I return to the subject for a news... not very good. For lack of time we are not going to go to Morocco with the pantone (and yes we are students, we have to work too!, not to mention the search for sponsors...). It is also for the sake of reliability...

Hi guys,

I did not receive anything on my mail ...

@+

Hello,

yes we will realize when it will be finished, either in a technical control, or by ourselves in our acien IUT.

A+

Hello, After a short time of absence, here is the progress of our system, the welds have been made: The reactor: https://www.econologie.com/fichiers/partager/PIC01955.jpg https://www. econologie.com/fichiers/partager/PIC01956.jpg https://www.econologie.com/fichiers/partager/PIC01957.jpg The G...

Hello

Yes no problem, I think I would put them on the forum, uh no actually .. I'm sure!
And I also thank the Pro Pantone to be present on this subject!

Ok thank you.

Measurements in perspective then, but how do you do to roll them?

Thanks ! I think positioning myself above the butterfly, I read that it was preferable, right? I also plan to install a second butterfly which will open at the same time as that of the gases, after the engine outlet and before the tapping with venturi after the air filter (it is understandable cke I say?:...

After a little scrapping to recover an exhaust line, we were able to start some parts of the system: the exhaust outlet with the holes to pass the reactor tube: https://www.econologie.com/ files/share/echapreacteurperce.jpg https://www.econologie.com/fichiers...

Thanks ! I think that we will cut one end of the exhaust tube the length of the GV (see a little longer), cut this end of the tube in half lengthwise, make the necessary holes, braze then resolder with an arc. On the exhaust of the 4L, there is a part that is completely ...

Here is the first piece we made, the steam generator: https://www.econologie.com/fichiers/partager/GV.jpg And the inner tube view came out: https://www.econologie.com/fichiers/ share/GVeclate.jpg It is 20 cm long. Length calculated with the formula available on the...