Siphon transformed into bubbler and clay balls?

Water injection in thermal engines and the famous "pantone engine". General informations. Press clippings and videos. Understanding and scientific explanations on the injection of water into engines: ideas for assemblies, studies, physico-chemical analyzes.
bpval
I posted 500 messages!
I posted 500 messages!
posts: 561
Registration: 06/10/06, 17:27




by bpval » 15/06/08, 19:21

Hello

AND DO NOT FORGET

Put some nuts

: Mrgreen:

Hello
0 x
PIF PAF POUM
yakakliker
I learn econologic
I learn econologic
posts: 17
Registration: 01/09/05, 19:12
Location: Calvados

I come back to the charge ....




by yakakliker » 19/07/08, 12:47

After these few posts, my stubborn character helping, so I decided to continue my experience:

So I bought a "bag of marbles" ... (6 €)

It is well noted above "rot-proof"

So I filled my bubbler with these balls and, in parallel I filled a glass jar of logs and water that I left in a corner of my studio to see the evolution of the mixture.

For now, no deposit found ....

For its effectiveness, I have for the moment other problems to solve ...

A finding however on the glass jar: the balls acting as mini-sponges, balls above the water level are still wet (about 1 cm above the water level).

Maybe a solution to optimize the humidification of the air ....

To be continued...
0 x

Go back to "Water injection in heat engines: information and explanations"

Who is online ?

Users browsing this forum : No registered users and 129 guests