Emission of smoke boiler Okofen

[Did67]

Pellet boilers have an air supply by controlled fan. They react and correct small variations, thanks to the pressure switch connected to the fireplace. Only in the event of a serious fault (blocked pipes or blocked chimney flue) will this fail ...

More precisely, there is a "time delay", which can be configured: the difference must "last" (for example one minute); this prevents instabilities linked, for example, to gales of wind causing the boiler to fail (however, I have been told of difficulties with the front outputs with PESKs like mine - this was proposed in the installation diagrams, before that in unfavorable situations, there are untimely defaults) ...

[Axoul]

Yes the 15cm are fine between the exit of the tube and the wall.

There is indeed a fan at the outlet for smoke extraction.
Do you have any courses of action that I can take this weekend I would like that to be settled because it becomes unbearable ...

[sicetaitsimple]

Yes the 15cm are fine between the exit of the tube and the wall.

Do you have any courses of action that I can take this weekend I would like that to be settled because it becomes unbearable ...

Unfortunately no. If the wall is 15 cm away and nothing changes when you open the garage door, the track I had considered was certainly not the right one.

Have you looked at the condenser side as recommended by Didier?

[Axoul]

No but I don't know where it is located ..

[Did67]

Here is the user manual, with, from page 23, the maintenance.

I do not see the tubes as there are on mine. Maybe another system ??? Perhaps also certain parts are reserved for professionals because they are considered too complicated / risky ...

Already runs the full cleaning program and then tries again.

http://www.enrdd.com/documents/document ... %200.6.pdf

[Did67]

In this diagram, page 11, it is not clear how the condenser is made up, shown to the right of the fireplace. "Fully automatic" ??? It surprises me all the same that there is no need to clean a little bistre from time to time ...

[Axoul]

I'm going to try to find the condenser and the pipes, but I'm having trouble knowing where it is. Could you show me what it looks like roughly?

[Did67]

On mine, it has nothing to do with what's on SMART.

A priori, according to the guide I had given you, you have to open a sort of half-moon hatch ... Start there, and see if it is not crowded.

[Axoul]

Could you enlighten me on the name and the usefulness of this part (a kind of stone that clogs the burn pot)? Thank you

[Axoul]