Save 32% Fuel 2 Engines Time With Acetone

[jonule]

??
Well, we talk about acting on fuel, not on the junk?

you should re-try 0.5%

[chevesne51]

Good evening everyone,

Not really in the subject, but to inform (André in particular),

It is true that it is poison this product, if you sniff too much in a place not ventilated enough, as I use 4litres to wash aluminum before painting, brushes for polyester ect ..

the uncured polyester is cleaned with white vinegar.
Much less expensive and polluting.

A+

[Other]

Hello

Good evening everyone,

Not really in the subject, but to inform (André in particular),

It is true that it is poison this product, if you sniff too much in a place not ventilated enough, as I use 4litres to wash aluminum before painting, brushes for polyester ect ..

the uncured polyester is cleaned with white vinegar.
Much less expensive and polluting.

A+

Thanks for the tip I will try

For acetone in the two-stroke, it was on these engines that I had the best results (Lawn boy lawn mower)
I walked with 1% acetone and klotz oil, synthetic castor oil was almost 50% more than without acetone.

The problems I encountered, after having increased the acetone dose again the needle of the carburetor rubber broke
I replaced the black rubber point needle by the new red tip, the ones that are more suitable for methanol fuel

A two-stroke engine when you deplete it also depletes the lubrication, microlights all know that a long descent to idle and you get the engine.
If you want to impoverish it like snowmobile riders, walk with special oil at low% .. in both times there is oil and oil ..

Andre

[HBK]

Hi,
raph94z for a MBK Rocket 2 engine time with a tank of 5,5litres, how much do you put acetone ..?
please
Peace